Polar Energy Conservation Systems

is proud to support

the revolutionary

fuel and emissions savings product line of

 

 

More horsepower and increased torque, reduced fuel consumption,

reduced carbon build up and maintenance, reduced emissions,

reduce costly sparkplug replacement, easier starting,

no more need to use stabilizers.

With the FITCH® FUEL CATALYST you will go farther using less fuel guaranteed.

 

PECS’s independent testing on two Yamaha 500XL snow machines in Cape Dorset over a three month period

showed an increase from 2.7 km/l to 3.6 km/l.

On a 45 liter tank that translates to an increase from 120 km to 160 km or 34%.

 

Other testing by PECS in Nunavut on vehicles and heating applications is resulting in similar savings.

 

If you live in Nunavut and use fuel, you will want to use this product.

 

Get

The FITCH® FUEL CATALYST today

and save money while helping Nunavut reduce emissions.

If you drive allot, such as Taxi’s and transport industry, this product is a must.

 

Available at a Northern Store near you.

For units not in store, fill out an order form, also available at the Northern Store, and we will bring it in for you.

Other locations in Nunavut contact PECS

867-897-7380

info@polarenergy.ca


Product Warranty

THE FITCH FUEL CATALYST IS BACKED BY A 90 DAY MONEY BACK GUARANTEE. IF YOU ARE NOT COMPLETELY SATISFIED WITH THE RESULTS, RETURN THE UNIT FOR A REFUND. (Provided the installation instructions were followed and the return of the product is based either on product defect or dissatisfaction with the product's performance.)

WARRANTY: (Official EPA Language)

The Fitch Fuel Catalyst device is guaranteed to be free from defects in material and workmanship for a period of 250,000 miles (defined by EPA in 40 CFR 85.2114), five years, or 5,000 operating hours from the date of installation.

Manufacturer reserves the right to repair or replace any failed or defective device, or return the purchase price to the buyer. This warranty does not cover damages resulting from collision, abuse, improper installation or failure to maintain the device as stated in the written instructions for proper maintenance and use. Return the defective device along with dated proof of purchase to the distributor from which the device was purchased so that distributor may handle your warranty claim in an expeditious manner.

Pursuant to 40 CFR 85.2114, the manufacturer warrants that the installation of The Fitch Fuel Catalyst on a vehicle will not cause the emissions noncompliance of the engine on which it is installed for the life to the catalyst from the date of installation. The manufacturer under this warranty will reimburse purchaser for all reasonable expenses incurred as a result of honoring a valid emission performance warranty claim which arises because of the use of the certified aftermarket part.

 

 

NOTE: Be sure to have a strong and accurate base line and follow all installation instructions and mounting suggestions before installing the Fitch unit. Accurate data collection is suggested to effectively assess the full benefits of the catalyst.

 
Fitch Units and Prices (CDN, includes shipping in Canada)

 

DROP-IN UNITS


F2T - are used to treat small engines under 3.5 hp, and all hand-held outdoor power equipment.
PRICE - RETAIL: $32.99*


F4T - are used to treat small engines over 3.5 hp such as motorcycles (under 350cc , 25 HP Max), outdoor power equipment, small outboard motors etc. The in tank unit, is simply placed in the fuel tank of the engine to be treated.
***As a stabilizer you may use one F4T unit for each six gallons (27 liters) of fuel tank capacity. The F4T in tank unit can also be used in conjunction with any in-line Fitch unit when fuel containing higher than normal contaminants or excess water is present. As well, in seasonal and stationary applications, where the fuel lies stagnant for long periods, the catalyst will help keep the fuel fresh.
PRICE - RETAIL: $49.99*


 

F5T - Power Sports Pack - Snowmobiles, Jet Skis, ATVs, Personal Watercraft, Motorcycles (single, double or split tank application), Outboard Motors, small tractors -(Two F4's in one packet)

NOTE: You must use both units in one vehicle to attain full results!!

NOTE: "Snowmobiles with under 10 gallon tank and under 150 HP Require 1 F5T pack."

"Snowmobiles with over 10 gallon tank or over 150 HP
               May Require one additional F4T Pack"

Special Note: Model Info (Snowmobile, ATV, Jetski, Motocross)
Casual recreational riders should install the F5T in the fuel tank directly.
***Competitive/ very aggressive riding over rough terrain/jumps should pre-treat a 10 gal fuel can with the F5T Fitch unit & fill their equipment with the treated fuel instead of installing directly in tank.

PRICE - RETAIL: $99.99*



IN-LINE UNITS

 

F100

Gasoline only- small garden tractors and agricultural equipment, small generators, and truck reefer units. 4 cylinder automotive non turbo charged engines up to Maximum 75HP

Diesel-under 4 cylinder only

Home Heating applications. (5 gph flow rate)

LENGTH DIMENSIONS END TO END: 3.6"
DIAMETER: 3"
FITTING SIZES: 9/16"-18 straight thread to 3/8" open

PRICE - RETAIL: $234.00*


F200
Gasoline-Cars Only!- 4 cylinder turbo, V6 cylinder, MAX5.7 liters/350 cu in/ up to Maximum 200 HP

Diesel- 4 cylinder engines up to 2.2 liter/135 cu in up to Maximum 125 HP
Outboard motors up to Maximum 200HP
Heating applications.
(10 gph flow rate)

LENGTH DIMENSIONS END TO END: 4.1"
DIAMETER: 3"
FITTING SIZES: 9/16"-18 straight thread to 3/8" open

PRICE - RETAIL: $277.15*


F300
Gasoline - Trucks/SUV/Auto-- All light duty V6 & V8 cylinder gasoline engines up to 6.8 liters/428 cu in/ up to Maximum 300 HP (Excluding V10's)

Diesel -- 4 cylinder engines up to 4.7 liters/290 cu in/up to Maximum 175 HP
Outboard and inboard motors up to Maximum 225HP.
*** Maximum 30 GPH flow rate. ***
LENGTH DIMENSIONS END TO END: 4.1"
DIAMETER: 3"
FITTING SIZES: 9/16"-18 straight thread to 3/8" open

PRICE - RETAIL: $382.95**


F400
Gasoline - All V10 and engines up to 8.6 liters/528 cu in/up to Maximum 400 HP (Excluding Dodge V10's)

Diesel - All light duty engines up to 5.7 liters/350 cu in/ up to Maximum 225 HP
Outboard and inboard motors above 225 HP up to 10 liters/588 cubic inches.
*** Maximum 60 GPH flow rate. ***
LENGTH DIMENSIONS END TO END: 5.5"
DIAMETER: 3"
FITTING SIZES: 7/8"-14 straight thread to 5/8" open

PRICE - RETAIL: $510.60*


F500
Gasoline- All engines up to 14.6 liters/860 cu in/ up to 500 HP-(including Dodge V10)

Diesel - All light duty engines up to 7.3 liters/460 cu in/up to Maximum 325 HP
*** Maximum 80 GPH total fuel flow rate or 325 BHP ***.
LENGTH DIMENSIONS END TO END: 6.4"
DIAMETER: 3"
FITTING SIZES: 7/8"-14 straight thread to 5/8" open

PRICE - RETAIL: $653.20*


F750
Gasoline- High performance auto/marine engines up to Maximum 750 HP or maximum fuel flow to 140 gph

Diesel:  CUMMINS, DURAMAX, POWERSTROKE ENGINES IN PASSENGER TRUCKS
- All Heavy Duty engines up to 8.6 liters/502 cu in/up to Maximum 450 HP
Marine, construction, standby generators,heavy duty engines up to Maximum 450 BHP.
*** Maximum 120 GPH total fuel flow rate. ***
LENGTH DIMENSIONS END TO END: 8.3"
DIAMETER: 3"
FITTING SIZES: 7/8"-14 straight thread to 5/8" open

PRICE - RETAIL: $962.55*


F1000
Gasoline -High performance engines up to Maximum 1000 HP or maximum fuel flow of 210 gph.

Diesel- All Heavy Duty engines up to Maximum 750 HP
-Marine,construction, standby generators, heavy duty engines up to Maximum 750 HP.
*** Maximum 180 GPH total fuel flow rate. ***
LENGTH DIMENSIONS END TO END: 10.11"
DIAMETER: 3"
FITTING SIZES: 7/8"-14 straight thread to 5/8" open

PRICE - RETAIL: $1,388.05*

 

Special Notes

Note 1: When in doubt always use the next larger unit. It is impossible to over treat the fuel, but it is possible to under treat. If the appropriate Fitch unit is not used, maximum results will not be obtained.

Note 2: Some Cars and Trucks containing aftermarket performance enhancing parts or exceedingly high horsepower may require larger size unit or additional drop in units.

Note 3: For larger engines or higher fuel flow rates, contact your local dealer for recommended application.

20% restocking fee will apply to any and all returned product and must be accompanied by sales receipt and original packaging in original condition.


*SHIPPING Included in above pricing in Nunavut and NWT

Payment:Visa/MasterCard/COD – Northern Stores

Direct from PECS - COD, Certified Check, Money Order,(VISA coming)


 

FOR ELECTRONIC ENGINES CHECK THE TOTAL FUEL FLOW INFORMATION FROM THE MANUFACTURER.
For example, the Detroit engines such as the 16V92 has a fuel flow of 186 GPH and in the DDEC version, it is 290 GPH


For larger engines or other applications contact

Polar Energy Conservation Systems

867-897-7380

info@polarenergy.ca

Nunavut Dealer